Cleaning And Maintenance; Technical Data - Dynamic MINI PRO Notice D'utilisation Et D'entretien

A
VAILABLE ATTACHMENTS (-> fig.5)
L - 4 BLADE KNIFE - Emulsifies sauce, mixes soups and veloutes...
M - 2 BLADE KNIFE - Chops, cuts and minces meat and fish, mixes vegetables, soups and vegetable purees
EN
N - BEATER DISC - to produce milkshakes, beaten egg whites, whipped cream,...
O - SKIMMER DISC - emulsifies sauces, produces mayonnaise

Cleaning and maintenance

N
ever clean this appliance with a water jet spray
N
ever immerse the motor block (B) into any liquid.
B
e careful: risk of cuts when cleaning the mixer attachment equipped with the blade.
T
o clean the inside of the blade guard (E) and the blade (F), immerse the blender tube (D) into clear water and let it run
for ca. 3 sec.
B
efore you clean the exterior of the blender tube (D) or the motor block (B), unplug the appliance form the wall
outlet.
C
lean the handle / motor block (B) with a slightly damp sponge or cloth. Clean the exterior of the blender tube (D) and
the blade guard (E) with running water under the faucet. If you are using a washing up liquid, completely remove it before
next use. The appliance is not dish washer proofed.
I
n case it should be necessary to exchange the blender tube (D), screw it off by holding the blender tube (D) and turn it to
the right (following the engraved arrow and the word "open"). If you reassemble the blender tube (D) precede wise versa.
Take care that the blender tube (D) is correct replaced before you plug in the appliance and start operation.
P
lease verify periodically:

Technical data

Model number:
Power source:
Power consumption:
Speed:
Power cord length:
Total length:
Mixer tube length:
Diameter of the blade protector:
Protection class:
Noise level:
Weight:
14
The condition of the power cord (H). If the power cord (H) is damaged, it must be replaced by the manufac-
turer, its after-sales service or a person of similar qualification to avoid any danger.
Potential leaks in the blender tube (D) (wear of the seal fig.4)
Condition of the attachments (L-O). Make sure blades are not chipped or bent.
After a drop an inspection of the entire appliance must be made.
MINIPRO
220-240 V~, 50-60 Hz
220 W
8.000 – 13.000 RPM
1,50 m
395 mm
160 mm
55 mm
Class 2
60 dB (A)
990 g