English - Philips City line reach & clean FC8408/02 Mode D'emploi

ENGLISH

6
Important
Only use Philips s-bag™ double-layer paper dustbags (FC8021).
Never use the vacuum cleaner to suck up water or any other liquid. Never suck up ashes
until they are cold.
When the vacuum cleaner is used to suck up fine dust, the pores of the dustbag may become
clogged, causing the passage of air through the dustbag to become obstructed.As a result, the
dustbag-full indicator will indicate that the dustbag needs to be replaced, even though the
dustbag is not full at all.
Never use the appliance without the Motor Protection Filter.This could damage the motor
and shorten the life of the appliance.
Never clean the appliance with water.
Connecting accessories
To connect the hose to the appliance, push it into the appliance and turn it clockwise (fig. 1).
To disconnect the hose from the appliance, turn it anticlockwise and pull it out of the appliance.
Button coupling (specific types only)
1 Connect the tube to the handgrip by pressing the spring-loaded lock button on the handgrip
and inserting the handgrip into the tube. Fit the spring-loaded lock button into the opening in
the tube ("click") (fig. 2).
To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the
handgrip out of the tube.
Use the same method to connect and disconnect the other accessories.
Telescopic tube
Adjust the tube to the length you find most comfortable during vacuum cleaning (fig. 3).
Reach & Clean nozzle
The Reach & Clean nozzle can be used on either carpets or hard floors.The nozzle can be
turned 360 degrees to 4 different positions, allowing you to also vacuum clean hard-to-reach
places in an easy way.When the nozzle is positioned lengthwise, the suction power is
concentrated at the front side of the nozzle (fig. 4).
To adjust the nozzle to the type of floor and the area to be cleaned, put your foot on the
indicated spot and then turn the tube until the nozzle is in the required position (fig. 5).
1 With the nozzle positioned breadthwise and the brush strip folded out, you can clean large
hard floor areas.Turn the tube until the brush strip pops out of the nozzle housing and the
nozzle is positioned breadthwise (fig. 6).
2 With the nozzle positioned lengthwise and the brush strip folded out, you can vacuum clean
small hard floor areas.Turn the tube 90 degrees anti-clockwise until it is positioned
lengthwise with the brush strip still folded out of the nozzle housing (fig. 7).
3 With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum clean
large soft floor areas.Turn the tube 90 degrees anti-clockwise again to position the nozzle
breadthwise and to make the brush strip disappear into the nozzle housing (fig. 8).
4 With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean
small soft floor areas.Turn the tube 90 degrees anti-clockwise again until it is positioned
lengthwise with the brush strip still folded in (fig. 9).
Crevice nozzle, brush nozzle and small nozzle
The crevice nozzle can be used either for cleaning narrow corners or hard-to-reach places.