Night Mode; Auto Standby; Apply Factory Settings - Sanyo FWSB415E Guide D'utilisation

2
On the Bluetooth device, switch
on Bluetooth, search for and select
SANYO FWSB415E
manual of the Bluetooth device on
how to enable Bluetooth).
3
When the Bluetooth connection
succeeds, the Bluetooth indicator
lights up.
• If no any bluetooth device is
connected in two minutes, press
on remote control to activate
PAIR
the paring mode again.
4
Select and play audio files or music on
your bluetooth device.
• During play, if a call is coming,
music play is paused. Play
resumes when the call ends.
5
To exit Bluetooth, select other source.
• When your switch back to
Bluetooth mode, Bluetooth
connection remains active.
Note
•
The music streaming may be interrupted by
obstacles between the device and SoundBar,
such as wall, metallic casing that covers the
device, or other devices nearby that operate in
the same frequency.
•
If you want to connect your SoundBar with
another Bluetooth device, press PAIR button to
disconnect the currently connection.

5.4 Night Mode

Night Mode is a digital Audio feature
equipped with Dolby digital decoder.
When you watch movie late at night,
lowering volume level during loud sound
scenes, dynamic range will be pressed
down and you miss some dialogue and
narration. With this "Night Mode" you can
control volume level down but still can
enjoy fair level of audio tone and voice.
1
In any mode, Long press CLASSIC
on remote control for 3 seconds to
switch night mode on or off.
(see the user
» The OPTICAL INPUT indicator
on the front panel of main unit
blinks three times when the night
mode is on.
» The OPTICAL INPUT indicator
on the front panel of main unit
blinks once when the night mode
is off.
Note
•
This product supports Dolby Digital and LPCM.
•
DTS is not supported.
•
Sampling frequency: 32KHz, 44.1KHz, 48KHz
5.5

Auto Standby

When playing media from a connected
device, the SoundBar automatically
switches to standby after 20 minutes if no
audio play from a connected device.
5.6 Apply factory
settings
You can reset your SoundBar to the
default settings programmed at the
factory.
1
On your remote control, press LINE
INPUT button.
2
Press MUSIC, VOL- and NEWS on
remote control within 3 seconds to
perform factory default settings.
» when the factory setting restore is
complete, the system shuts down
into standby mode and restart.
EN 11