Functional Description - Makita 3709 Manuel D'instruction

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting bit protrusion
1
5
2
► 1. Base 2. Scale 3. Bit protrusion 4. Clamping nut
5. Adjusting screw
To adjust the bit protrusion, loosen the clamping nut and
move the tool base up or down as desired by turning the
adjusting screw. After adjusting, tighten the clamping
nut firmly to secure the tool base.
Switch action
► 1. Switch lever
CAUTION:
• Before plugging in the tool, always be sure that
the tool is switched off.
To start the tool, move the switch lever to the I (ON)
position. To stop the tool, move the switch lever to the O
(OFF) position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing trimmer bit
3
1
4
► 1. Loosen 2. Tighten 3. Hold
CAUTION:
• Do not tighten the collet nut without inserting a
bit, or the collet cone will break.
• Use only the wrenches provided with the tool.
Insert the bit all the way into the collet cone and
tighten the collet nut securely with the two wrenches.
To remove the bit, follow the installation procedure in
reverse.
4 ENGLISH
1
2
3