Using The Machine - Soba BABYDUCK WA210 Mode D'emploi

WASHING MACHINE BABYDUCK WA210
III. USING THE MACHINE
1. Loading the machine
Open the door and place the laundry in the drum, then close the door firmly; the machine will not
start if the door is not closed properly.
2. Selecting washing programme
Choose the programme according to the type of fabric you are going to wash by referring to the
programme list.
Attention: Never turn the button anticlockwise!
Turn the button so that the arrow points to the programme required; never point the arrow be-
tween two programmes.
3. Selecting washing temperature
Turn the temperature dial to the required position. If you want a cold wash leave the button in the
«0» position.
Do not exceed 40°C in the wool programme.
4. Selecting the function
If necessary, activate the special function button according to the control pane.
N.B.: ANY FUNCTION BUTTONS THAT ARE NOT ACTIVATED MUST BE IN THE NEUTRAL POSI-
TION.
5. Dosing and adding washing products
Put the detergent and other products in the correct compartments. Compartment 1 is used for
washing powder, compartment 2 for fabric softeners, whiteners, stain removers etc. When using
programmes 1, 2 and 3, the fabric softener is run in during the first rinsing cycle to produce an
anti-allergenic effect. If you want a classic fabric softener rinsing cycle, pour the fabric softener
into compartment 2 and start the programme again in position 4.
Make sure you use a good quality detergent to avoid excessive foam.
6. Filling and starting the machine
Turn the water tap on full and check that there is no leaking.
Press the ON/OFF button to start the machine; it will run automatically until the end of the cy-
cle.
The machine will stop when the programme dial reaches the "●" position.
7. Unloading the machine
Press the ON/OFF button to set to the STOP position. Wait for two minutes then push the button
to open the door; remove the garments.
5
INSTRUCTION MANUAL