Spare Parts; Transport - WOLFF AKKU JUNIO-STRIPPER 18V-230 V SET Traduction Du Mode D'emploi Original

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

► Only charge the batteries with chargers that are re
commended by the manufacturer. With a charger that
is suitable for a certain type of battery, There is a risk
of fi re when using other batteries is used.
► With pointed objects such as The battery can be
damaged by a nail or screwdriver or by external force.
An internal short circuit can occur and the battery can
burn, smoke, explode or overheat.
► To identify the power tool use only adhesive labels.
No holes drill into the housing.
► Spindle lock only when stationary Press the
grinding tool.
4.8 Clean the dust fi lter regularly Figure I
► Remove the dust fi lter and dry it Blow out
compressed air.

5.0 Transport

To avoid injury dismount the blade while transporting
the machine. Pull out the plug from the mains.
6.0 Maintenance
► Before carrying out any work on the power tool,
disconnect the mains plug from the socket or the
battery from the device.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean. The machine
must then be sent to an after-sales Service agent.
Addresses are listed in the Section "After- sales
service and customer assistance".
► The motor is equipped with shut-off charcoal which
shuts off the motor when the wear limit is reached.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the machine number specifi ed on the
type plate of the machine.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff -tools.de

6.1 Spare parts

Spare parts can be found on the internet at:
http://webcatalog.wolff -tools.com
7.0 Troubleshooting
Fault
Possible cause
The machine
charging the
does not start
battery
Higher exer-
Knife blunt
tion of force
required while
working
high vibration
Wear parts of
the machine are
knocked out
EN
Remedy
Charge bat-
tery in station
Replace knife
Send in the ma-
chine for repair
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Akku junio-stripper 18v-115 v set010328010329010344

Table des Matières