Technical Data; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL Bavaria BPS 800 E Instructions De Service

Anleitung BPS 800 E_SPK1:_
GB
The general rules for tool speed in cutting operations
apply.
Setting the pendulum action (Figure 1)
Position 0: No pendulum aktion
Position 1: Slight pendulum action
Position 2: Moderate pendulum action
Position 3: Intensive pendulum action
Dust extraction (Figure 1)
The jigsaw is equipped with an adapter for the vacu-
um cleaner connection. Any vacuum cleaner can be
connected to the extraction opening at the rear end
of the jigsaw. Should you require a special adapter
for this purpose, please contact the manufacturer of
your vacuum cleaner.
Changing the saw blade (Figure 2)
Switch off the jigsaw and remove the plug from the
power socket before changing the blade or carrying
out any other work on the jigsaw.
Use the supplied hexagon-socket spanner to undo
the two screws 1 and 2 on the ram (Figure 2). Slide
the saw blade into the guide slot and up to the stop
between the piston rod and the retention clip. Use
the supplied hexagon-socket spanner to tighten the
two screws. The teeth of the saw blade must face in
cutting direction. Make sure that the saw blade sits
properly in the guide slot of the ram and roller.
Adjusting the base (Figure 3)
For mitre and bevel cuts you can swivel the base by
up to 45° in either direction after undoing the two
screws (a) on the bottom. The angles 15°, 30° and
45° are marked but you can adjust the saw to any
angle between these markings as required.
To adjust the cutting angle, undo the two screws (a)
until you can just about move the blade. Adjust to the
required angle and re-tighten the two screws.
ON/OFF switch for laser/LED (Figure 4)
You can switch the laser and the LED light ON and
OFF with the switch 12.
The laser beam marks the cutting path on the work-
piece.
Pos. 0 Laser and LED off
Pos. 1 Laser on
Pos. 2 LED on
Pos. 3 Laser and LED on
8
12.12.2006 10:05 Uhr Seite 8

5. TECHNICAL DATA

Nominal voltage: 230 V ~ 50 Hz
Power consumption:
Cutting rate: 0-3000 strokes/min
Stroke height:
Cutting depth in wood:
Cutting depth in plastic:
Cutting depth in iron:
Mitre cuts: up to 45° (left and right)
Sound pressure level L :
pA
Sound power level L :
WA
Vibration a
hv
Double isolation
Weight
Laser class
Laser wave length
Laser output
6. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
800 W
20 mm
80 mm
25 mm
10 mm
87,8 dB(A)
98,8 dB(A)
2,8 m/s 2
II /
2,3 Kg
2
650 nm
≤ 1 mW