Oase FiltoSkim 3000 Notice D'emploi page 5

- English -
5. Insert 2 temporary nails into top corner holes of the nut plate
and gently push nails through liner into top corner holes of the
skimmer. Place face plate onto nails.
Notes: Temporary nails are NOT INCLUDED.
6. Assemble the face plate onto the face of the skimmer by using
supplied screws. This securely seals the liner to the skimmer.
○ Carefullly install the screws, then remove the temporary
nails and attach the last two screws.
○ Tighten all of the screws.
NOTE: Door hinges positioned on face plate must face out
and be at the bottom.
7. Carefully cut and remove liner section from opening, then
wipe off the excess sealant around the opening.
8. Install door by flexing hinge pins inward, then snapping into
door opening.
Note: the styrofoam should face the inside of the unit when
door is vertical.
9. Assemble the coupler, gasket and adapter (Part E,D1,F)
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or
email us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
5.
temporary
nails
6.
door
hinges
7.
8.
9.
Coupler
Gasket
Adapter
5