Beta 599 DGT/30 Mode D'emploi page 12

ACTIVATION DURING SLEEP MODE
– The wrench will auto sleep after about 5 minutes idle for power saving.
Press to wake up the wrench during the sleep mode.
RESETTING WRENCH
– If the wrench does not function normally, press
LOW BATTERY VOLTAGE PROTECTION
– If the battery voltage is under 2.3 volts, the wrench will display a battery symbol and then turn off
after a while.
SETUP
1 - Power On/Clear
2 - Unit Selection/Setting
3 - Set Torque Value
Use peak hold mode (P) to keep the maximum value achieved while applying torque displayed for a
few seconds.
Pressing (C) will allow the preset value to be restored.
Whereas using track mode (T) will allow the applied torque range to be viewed, without the
maximum applied value being displayed.
To set the chosen mode go to:
STEP 3: PEAK HOLD / TRACK MODE SELECTION
together to reset the wrench.
1 2 3