Residual Risks; Safety Instructions; Setting / Adjustment; Mains Connection - Mafell FM 800 Notice D'emploi

The appliance is not designed for non-stop industrial
operation. The maximum speed can be referenced in
chapter 2.3 Technical data.
The milling motor is considered an incomplete
machine. The incomplete machine may only be
commissioned once it has been determined that the
machine that is to be incorporated into the incomplete
machine complies with the provisions of the current
and valid Machinery Directive.
Please also note the corresponding warranty
conditions for the
supplementary appliances.

2.7 Residual risks

Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use will always
remain.
- Breakage of the tools and risk of the tools or parts
of them being hurled away.
- Touching live parts with the housing open and the
mains plug not removed.
- Hearing can be impaired when working for long
periods without ear protectors.
- Emission of hazardous dusts (all types) during
longer lasting operation without extraction. Please
note the safety data sheet of the material to be
machined.
3

Safety instructions

Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
General instructions:
- Children and adolescents must not operate this
machine. This rule does not apply to young
persons receiving training and being supervised by
an expert.
- Never work without the protection devices
stipulated for the respective operating sequence
milling motor and
and do not effect any modifications on the machine
that could impair safety.
- Damaged cables or plugs must be immediately
replaced.
- Avoid sharp bends in the cable. Especially when
transporting and storing the machine, do not wind
the cable around the machine.
Do not use:
- Damaged tools or tools that have changed their
any
shape.
- Blunt tools due to the excessive engine load.
- Tools that are not suitable for the tool speed during
idling.
Instructions on the use of personal protective
equipment:
- Always wear ear protectors during work.
- Always where a dust mark during work.
- Always wear protective goggles during work.
Instructions on operation:
- Do not reach with your hands into the danger zone
of the tool.
- Examine the workpiece for foreign objects.
Instructions on service and maintenance:
- Regular cleaning of the device is an important
safety factor.
- Only original MAFELL spare parts and accessories
may be used. Otherwise, the manufacturer will not
accept any warranty claims and cannot be held
liable.
4

Setting / Adjustment

4.1 Mains connection

Prior to commissioning make sure that the mains
voltage complies with the operating voltage stated on
the machine's rating plate.

4.2 Selection of tools

Please use the collets listed in chapter 8 Optional
accessories.
-14-