Operation; Operating Elements; Testing The Temperature Of The Water When Using For The First Time; Starting The Shower Function - TECE One Mode D'emploi

3. Operation

Operating elements

EN
The TECEone is operated intuitively using the right and left regulators:
ƒ Water flow regulator (A): use this regulator to open the water supply to the
shower arm and to regulate the intensity of the water jet. After a certain
volume of water starts to flow, the shower arm extends "automatically" out-
wards.
ƒ Temperature regulator (B): use this knob to set the temperature of the water
for washing your bottom.

Testing the temperature of the water when using for the first time

ƒ Turn the temperature regulator as far as it will go, to the highest possible
temperature.
ƒ Hold a suitable container (e.g. cup) in front of the shower arm.
ƒ Turn the water flow regulator and carefully test the water to see whether the
temperature is at a comfortable level (factory setting is 38 °C). If the tempera-
ture is clearly too high, the temperature must be reset by a qualified special-
ist.
ƒ Turn the temperature regulator to the required temperature or to the middle
position.
ƒ Turn the water flow regulator as far as it will go, to turn off the water supply.

Starting the shower function

ƒ If necessary, turn water flow regulator only slightly: the shower arm does not
yet extend and cooled water may run into the ceramic, at the same time the
shower arm is rinsed and washed with water (E).
ƒ Fully turn the water flow regulator: The shower arm now extends completely
and you can start washing with water (F).
ƒ You can increase or reduce the volume of water by turning the water flow
regulator until you achieve the required result.
ƒ You can set the required temperature of water by turning the temperature
regulator – including during operation.
ƒ To turn off the shower function, turn the water flow regulator back as far as it
will go.
14