Lifting Off For The First Flights; Making Flight Adjustments - Horizon Hobby Blade CX4 Manuel D'utilisation

Lift ing Off for the First Flight:
1. Place the helicopter on the ground with the tail pointing toward you.
2. Move the throttle stick smoothly to the 1/3 throttle position. The rotor blades will spin and the helicopter will climb. Climb to 3–5 feet
(1.0–1.5 meters) high. Reduce and add throttle as needed to hover and descend.
Use smooth control stick movements when you are fl ying the helicopter. Always use small control stick movements and keep your fi ngers on the
control sticks. If you notice that the helicopter wants to turn to the left or right, some steering adjustments (trim) may be necessary.
Tip: Always move the throttle to zero immediately if the helicopter crashes.

Making Flight Adjustments

Left or Right Rotation (Yaw)
The rudder trim lever makes small adjustments to the fl ight direction of the helicopter. If the nose (front) turns right, slide the trim lever until the
rotation stops and the nose stays in place.
If full rudder trim still does not prevent the heli from yawing, please refer to the main motor proportional mix trimmer pot adjustments on
the following page.
If the heli turns left, then trim right.
Left or Right Transition (Roll)
If the helicopter moves sideways, slide the aileron trim lever in the opposite direction the helicopter is moving.
If the heli moves left, then trim right.
Forward or Backward
If the helicopter moves forward, slide the elevator trim lever in the opposite direction the helicopter is moving.
If the heli moves back, then trim forward.
EN
If the heli turns right, then trim left.
If the heli moves right, then trim left.
If the heli moves forward, then trim back.
8