Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Problem
Camera does not turn on.
Replace the batteries with fresh ones (see chapter "INSERTING OR CHAN-
GING BATTERIES")
Camera does not capture images / videos.
Check the batteries and change them if necessary.
Insert a freshly formatted SD card.
Night images are too dark.
Check that the power saving mode is set to „ON" and replace the batteries.
Only photos are being sent, even though the
In the app you will only see photos. When a video is made, a single sample
trail camera is set to "video" mode.
photo is sent to the app. If you want to access the videos, please retrieve
the data directly from the SD card.
"Low battery" is displayed.
The batteries are almost empty and must be changed.
Photos without animals.
Make sure that there are no branches or other objects within the sensor's
operating range that could cause faulty recordings due to movement.
Overexposed night images
Select a location to mount your camera so that it is not affected by reflecti-
ve signs and windows or the like.
Camera is not sending photos
Check if the data transmission has been activated in the app.
46
46
Solution
Problem
After changing locations, the camera is not
If the camera has already found a strong network, it will repeatedly attempt
sending images
to log in to establish the fastest possible connection. At a new location, this
may cause delays during the first connection setup. You can speed this up
by manually uploading one or two images. To do this, you must perform the
following actions on the trail camera: Activate SETUP mode › OK › MENU ›
Send › OK If the signal strength of your original network is too weak at the
new location, a corresponding error message will appear ("Signal strength
weak"). Immediately carry out the manual transmission procedure again. In
this way, your camera learns „the hard way" that a new network is available.
Solution
47
47
Publicité
Chapitres
Table des Matières
