Storage; Cleaning - Minox DTC 1200 Mode D'emploi

Notifications
You can allow notifications if you wish to be informed about
all new recordings and other important camera events. These
can appear as a push message directly to your mobile phone or
be sent as an email to the address used when setting up your
MINOX account.
Settings
The functions for recording images and videos can be easily
made here, no matter where you are. You can also set the ca-
mera's GPS location, set the menu language on the camera (you
can control the app's display language in the „More" menu) and
check the remaining memory on your SD card.
Location
These are the last reported GPS coordinates of your trail ca-
mera.
Name
Display and change the name of your trail camera.
42 42
User
If you want to invite additional viewers to your trail camera, you
can generate invitation codes here and also see which viewers
are already registered to your trail camera.
Of course you can also remove the invited viewers here.
Delete & unblock
If you want to resell your trail camera or take it out of service
for any other reason, you can unblock it here.
Please note that you must first cancel your data transfer sub-
scription. Only then can you delete the trail camera from your
list.
ATTENTION!
Deleting a camera from your list means that all images in the
cloud that were taken by your camera will be lost. However,
data on the SD card will be retained.
ATTENTION!
After deleting the camera, another user can rescan the code in
the cover of the camera and use the trail camera as their own.

STORAGE

When not in use, disconnect the trail camera from the power
supply and store it in a clean and dry place, out of the reach of
children. Remove the batteries before storing.
To avoid damage during transport, pack the trail camera in the
original packaging.

CLEANING

DANGER!
Water that has penetrated into the housing can cause a
short circuit. Never immerse the trail camera in water. Make
sure that no water enters the inside of the housing.
WARNING!
Improper handling of the trail camera may result in damage.
Do not use any aggressive solvents / cleaning agents, brus-
hes with metal or nylon bristles, or sharp or metallic clea-
ning objects such as knives, hard spatulas and the like. These
can damage the surfaces.
Never put the trail camera into a dishwasher. This will dest-
roy the trail camera.
1. If the camera is connected to a power adapter, disconnect it
before cleaning the camera.
2. Disconnect all other connections.
3. Remove all batteries.
4. Use a slightly moistened cloth to wipe the outer surface of
the camera. Leave the trail camera to dry completely.
43 43