Makita HR3011FC Manuel D'instruction page 13

3. Dispose of the dust, and then clean the filter.
Replacing filter of dust case
1. Remove the dust case while pressing down the
lever of the dust case. (Refer to the section for dispos-
ing of dust.)
2. Open the filter cover of the dust case.
► 1. Filter cover
3.
Remove the filter from the filter case.
► 1. Filter 2. Filter case
4. Attach a new filter to the filter case, and then
attach the filter cover.
5. Close the cover of the dust case, and then attach
the dust case to the dust collection system.
Replacing sealing cap
If the sealing cap is worn out, the performance of the
dust collection decreases. Replace it if it is worn out.
Remove the sealing cap, and then attach a new one
with its protrusion facing upward.
► 1. Protrusion 2. Sealing cap
OPERATION
1
CAUTION:
handle) and firmly hold the tool by both side grip
and switch handle during operations.
CAUTION:
piece is secured before operation.
CAUTION:
even the bit gets stuck. Loss of control may
cause injury.
CAUTION:
Before using the dust collection system with the
tool, read the section about the dust collection
system.
1
2
13 ENGLISH
1
2
Always use the side grip (auxiliary
Always make sure that the work-
Do not pull the tool out forcibly
For HR3011FC, HR3012FC only