Makita HR3011FC Manuel D'instruction page 11

NOTE: The dust collection system collects the gener-
ated dust at a considerable rate, but not all dust can
be collected.
Installing or removing the dust
collection system
NOTICE:
Before installing the dust collection
system, clean the joint parts of the tool and the
dust collection system.
Foreign matters on the joint parts may cause it diffi-
cult to install the dust collection system. Particularly
the foreign matters on the electrical interface may
cause malfunction.
If any dust remains on the air duct, the dust comes
into the tool and causes jam in the airflow or break-
age of the tool.
Hook the dust collection system on the tool, and then
insert the dust collection system all the way, until it locks
in place with a little double click.
After that, make sure that the dust collection system is
securely installed.
► 1. Air duct
When removing the dust collection system, press the
lock-off button.
► 1. Lock-off button
Adjusting the nozzle position of the
dust collection system
CAUTION:
or others when releasing the nozzle by pushing
the guide adjustment button.
Push in the guide while pushing the guide adjustment
button, and then release the guide adjustment button at
the desired position.
1
► 1. Guide 2. Guide adjustment button
11 ENGLISH
Do not point the nozzle at yourself
1
1
2