Würth PINPULLER SPOT Traduction Des Instructions D'origine page 14

Connecting the welding gun
▸
Insert the power plug of the welding gun in the
power socket [5] and lock by turning clockwise.
▸
Insert the control plug of the welding gun in the
connection socket [7].
Connecting the dent killer
▸
Insert the power plug of the dent killer in the
power socket [4] and lock by turning clockwise.
▸
Insert the control plug of the control lead in
the connection socket [3] and lock by turning
clockwise.
▸
Switch the device on at the mains plug [9].
The device performs a self-test. "Würth PinPuller®
3
Spot 50 Hz" is output to the display [1].
If the device does not detect an error, the soft-
3
ware ID number is shown briefly on the display.
The device automatically selects the manual set-
3
ting of the last tool used.
The last used values are output to the display.
3
Programming
▸
To select a tool or the type of start, press the right
or left arrow keys [8].
Selection options
AUTOSTART
ON 0.3s
OFF
Type of start Welding gun
▸
To switch Autostart on or off, press the up or
down arrow keys [8].
Information
If Autostart is activated, welding starts
automatically as soon as the welding
gun comes into contact with the plate.
▸
To adjust the time delay between contact
and start, press "+" or "-" [2].
If Autostart is activated, this symbol is
3
displayed in the program between the
arrow keys.
The device has two independent modes:
• Manual setting
• Synergetic setting
14
3 3
43 % 43 %
Dent killer
Both modes are available for use of the welding gun
and also the dent killer.
▸
To switch between the two modes press the up or
down arrow keys [8].
Information
After switching on, the device first auto-
matically selects manual adjustment.
Manual setting
In this mode, you can manually set the values for
time and current. To do this, press key "+" or "-" [2].
The time value symbol flashes for approximately
3
3 seconds. While the symbol is flashing, you can
either adjust the time or change to current value
setting.
▸
To adjust the time press "+" or "-" [2].
When the time value symbol stops flashing, the
3
set value is programmed.
▸
To change to current value setting, press the
down arrow key [8].
The current value symbol flashes.
3
▸
To change the value, press "+" or "-" [2].
When the current value symbol stops flashing, the
3
set value is programmed.
Synergetic setting
In this mode you can use the available, already
preset programs. In each case these are optimised
for the intended purpose.
▸
To switch from manual to synergetic setting, press
the up or down arrow keys [8].
The purpose, time and current values are output
3
to the display.
▸
To make fine adjustments, press "+" or "-" [2].
The bar indicator on the display with zero line
3
shows the fine adjustment made.