Technical Data; Intended Use; Device Elements - Würth PINPULLER SPOT Traduction Des Instructions D'origine

Main supply
Capacity rating at 50 %
Normal rating at 100 %
Max. input short circuit current
Max. output short circuit current
Heating current at 100 %
Idle speed output voltage
Insulation class
IP Rating
Mains cable/stipulated extensions
Required mains supply protection
Fuses (gG)
Noise level
Vibration level
Dimensions
Weight

Intended use

The device is intended solely for the welding on of
pulling members (e.g. PinPuller
panel pulling with the carbon electrode on vehicle
panels. Any other use or use outside this scope is
considered improper use.
The user alone is responsible for damage
resulting from improper use.

Device elements

Overview [Fig. I]
1 Display
2 "+"-/"-" key
3 Dent killer connection socket
4 Dent killer power socket
5 Welding gun power socket
6 Earth connection power socket
7 Welding gun connection socket
8 Arrow keys
9 Power switch
10 Mains lead

Technical Data

230 V, 50 Hz
2 kVA
1.4 kVA
50 A
1600 A
200 A
7 V
F
IP21
L ≤ 15 m, L
overall
Plug
Slow fuses (aM)
Circuit breaker (characteristic C)
< 70 dB(A)
< 2.5 m/s²
285 × 180 ×320 mm
16 kg
® electrodes) and for
= 30 m
overall
Start-up
Attention !
Do not connect the device to standard low voltage
leads for household power supplies!
Observe the information of the device's type plate
and the technical data.
▸
Position the device on a level surface.
▸
Plug in the mains plug.
▸
Insert the mains cable plug in the earth connec-
tion power connector [6] and lock by turning
clockwise.
▸
Clamp the copper shoe of the earthing cable on
to the body part being worked on.
2.5 mm², 4 mm²
16 A
16 A
16 A
13