Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The Answering Machine Is Not Answering
-
Check that the unit is switched on
-
Check that the telephone cable and the mains adapter are correctly
connected
The Answering Machine Does Not Respond to Remote Control
-
Check that the telephone you are using to remotely access the answering
machine is tone dialling.
-
Telephones that generate only a short tone signal when pressing a button
may not allow you to remotely access your machine. In this situation please
use a separate tone transmitter.
-
Try holding the buttons down longer, approximately 1 second per digit.
I can't hear the outgoing message very well
-
Record a new outgoing message.
-
Speak closer to the unit/microphone when recording.
The line is disconnected when someone leaves a message:
-
If the answering function is set to A2 mode. The call will be terminated
after playing the OGM the caller cannot leave any message (France only).
-
The incoming message may be over 60 seconds in length. After this time,
the call will be disconnected.
-
If an incoming caller pauses for approximately 7 seconds while leaving a
message the call will be disconnected, as the voice control function will
believe that they have hung up.
I hear a tone sequence, but nothing happens when I press the playback
button:
-
There are no incoming messages.
If the answering machine still does not work, refer to page 38.
www.doro.com
Other
English
41
Publicité
Table des Matières
