Doro Titan Manuel D'utilisation page 31

Battery
To ensure that messages and time/date information will be kept during a
possible power cut (max. 16 hours), a 9V – PP3 battery is required (not supplied).
When the battery is running low, the display will flash
as soon as possible.
Use only a high quality Alkaline battery.
1. Ensure the telephone line cord is disconnected.
2. Remove the screw that holds the battery cover in place and remove the
battery cover.
3. Connect the battery observing correct polarity.
4. Replace the battery cover and refit the screw.
Connection
Once the back-up battery has been installed.
1. Connect the telephone line cord plug to the T socket at the rear of the
unit.
2. Plug the other end into the telephone network socket (using adapter plug
if required).
3. You will hear a click when the modular plug is correctly in place.
4. Connect the mains adapter to the Y socket at the rear of the unit and
then to an electrical mains socket.
5. When the mains adapter has been connected, the unit will perform a self-test
that takes approximately 20 seconds. During this time the display will count
upwards, then a long beep is heard.
6. Before you can use the answering machine you must record an outgoing
message (please refer to page 34). You should also set the day/time stamp
function (please refer to page 32).
For units purchased in Switzerland you can also select an operating language,
please refer to page 33.
Switching the Answering Machine On/Off
The answering machine can be switched ON or OFF using the
ON position, incoming calls will be answered by the answering machine, in the
OFF position no calls will be answered and the display will show
www.doro.com
Installation
English
, change the battery
bL
button. In the
!
.
--
31