Lindy 38114 Manuel Utilisateur page 4

User Manual
Installation
Important! Before starting the installation, please ensure that all devices are powered off.
The following steps are for an installation using HDMI equipment, if you are using DVI
equipment, please substitute the HDMI cables for DVI to HDMI cables where required.
1. Connect your HDMI source to your HDBaseT Transmitter/Splitter/Matrix unit using a HDMI
cable (maximum length 5m).
2. Connect one end of the Cat.5e/6/7 cable (max. length 70m) to the HDBaseT port on the
Transmitter/Splitter/Matrix and the other end to the HDBaseT port of the Face Plate
Receiver. Use solid core installation cable of at least Cat.5e UTP.
3. Use another HDMI cable (maximum length 5m) to connect your HDMI display device to the
HDMI output port on the Receiver unit.
4. For additional Infrared remote signal functionality, connect the included IR Extension Cables
to the Transmitter/Splitter/Matrix and Face Plate Receiver units.
5. At the Transmitter/Splitter/Matrix side, place the IR Emitter Eye in front of the HDMI source
devices IR receiver. At the Face Plate Receiver side, place the IR Receiver Eye in a location
where it may easily receive the signal of your IR remote, and connect it to the IR1 Extender
port.
6. Plug the DC power supplies into the Transmitter/Splitter/Matrix and Receiver units and
switch on.
7. Power on your HDMI Source and Display to complete the installation.
The diagram below shows a typical installation with the Face Plate Receiver connected to a 4
Port HDBaseT Splitter, with the IR modules connected to allow control of the HDMI source
equipment via the Face Plate Receiver.
BluRay Player
HDMI 1:4 Splitter C6-100m
Troubleshooting
There is no display on the screen.
 Check that the DC plug and jack used by external power supply are firmly connected.
 Check that the Cat.5e/6/7 cable is plugged in correctly and that the Link Status LED is lit.
 Check that the HDMI source and display are both powered on, active and that the HDMI
LED is Lit.
 Power off all the devices, then power on in this order: first, the transmitter unit, then the
display and finally the source.
 For several HDMI devices it may be helpful to unplug and replug their HDMI connection to
re-initiate the HDMI handshake and recognition.
 Reduce the length of Cat.5e/6/7 or HDMI cable used, or use a higher quality cable.
IR Emitter
Face Plate Receiver
IR Receiver
HDMI Cable
Cat 5e/6/7 Cable
2
English
HD TV
BluRay Player
IR Remote