JMA BT MULTIUSER PRO Manuel D'utilisation page 28

2 USING THE APP
2.3 Sending Open Commands
Once the remote control has been linked
and the open button configured on the
home screen, the JMARemotesUSER app
can now be used to send commands to the
M-BT remote control connected to the BT
Multiuser Box and activate the door opening
mechanism. Make sure that the M-BT remote
control is transmitting. To do this, hold
buttons 2 and 3 until the green LED starts
to flash.
As soon as the M-BT remote control starts to
flash, release the buttons. The remote control
will now be transmitting constantly and the
app will be able to locate and activate the
corresponding buttons.
28
Generally speaking, the app will take between
5 and 10 seconds to detect the remote control
that is transmitting provided that you are within
Bluetooth range. Once detected, the buttons
are activated and you will be able to press them
from the app to send the opening command.
When the remote control receives the
opening command and activates the RF
connection, the button will be deactivated.
Once the remote control has finished the
RF transmission to the door receiver, the
Bluetooth signal is reactivated and the
app can detect it in order to reactivate the
buttons.
Buttons from up to 4 physical M-BT remote
controls can be active on the home screen if
one button from each has been configured.