ProfiCare PC-HTD 3030 Mode D'emploi page 25

Accessories
• Attach a nozzle if necessary.
- You can dry single hair locks by concentrating the flow
of hot air with the hairdressing nozzle.
- The diffuser is the ideal solution to dry curly hair
without losing volume.
• In order to remove the nozzle, let the appliance cool
down. You can speed up that process by pressing the
COOL button for approx. ½ minute during operation. You
may then simply remove the nozzle.
Electrical Connection
1. Unwind the mains cable completely.
2. Before inserting the plug into the socket, make sure that
the mains voltage to be used matches that of the appli-
ance. You can find this information on the nameplate.
3. Connect the appliance to a properly installed earthed
socket.
Use
1. Turn the appliance on with the bottom switch on the
handle. The appliance is in standby mode.
2. Select an air stream level on the handle (bottom switch):
Position 0: off
Position : gentle stream of air
Position : strong stream of air
The control lamp now illuminates.
3. Setting the Temperature level (top switch):
Position : low temperature
Position : medium temperature for gentle drying
and shaping
Position : high temperature for rapid drying
WARNING:
• Before cleaning remove the mains lead from the socked.
• Under no circumstances should you immerse the appliance in
water for cleaning purposes. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Clean the housing with a soft, dry cloth without additives.
PC-HTD3030_IM
4. Now touch the sensor surface and the hair dryer will start
operating in the setting of your choice.
NOTE:
If you want to interrupt operation for a short time, put the
appliance aside. The appliance will enter the standby
mode. The settings on the hair dryer are retained.
COOL (Cold Air)
With this switch you can stop the heating process.
Hold the button down in this position according to the de-
sired interval length. When the button is released it returned
automatically to the initial position.
Ionizing Function – Reduction of Static in Hair
The appliance is also fitted with an ionizer which gives off
negative ions with the air flow when switching on. This pro-
cess supports safe, gentle drying of hair and also promotes
a better hair structure, maximizes hair volume, provides for
a silky finish and also reduces static in the hair.
This process is particularly gentle on stressed hair.
Switch-off
Set the switch to "0" after use. The control lamp turns off.
Disconnect the mains plug from the socket.
Storage
• Leave the appliance to cool down before putting it away!
• Hang the appliance up by the suspension eye.
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the appliance, as over
time this may result in the cable breaking.
• Check the mains cable regularly for damage.
Cleaning
Air Intake Grill
Please clean the grill on the air intake side of the hair dryer
regularly in order to avoid excessive temperatures as a
result of heat accumulation.
25
25.09.18