Connecting Cable - AKG Acoustics HSC 171 Mode D'emploi

3. Plug the XLR connector into the desired microphone input.
4. Switch power to the mixer ON.
The microphone cable is welded to the headphone cable. If the head-
phone output is too far away from the microphone input, you can sim-
ply pull the microphone cable away from the headphone cable. The
sliding bush lets you bundle the separated cables together again.
The microphone arm swivels through an arc of 270 degrees, allowing
you to put the headset on with the microphone sitting in front of either
the left or right corner of your mouth as required by the job at hand or
dictated by available space.
MUTE
ON
The microphone arm of each model features an automatic ON/MUTE
switch.
HSC 171/271, HSD 171/271/Single
3 Setting Up
3.2.3 Connecting
Cable
Fig. 2: Separating
microphone and head-
phone cables.
Refer to fig. 2.
3.3 Putting the
Headset On
Fig. 3: Two ways of
wearing the headset.
Refer to fig. 3.
3.4 Switching the
Microphone ON/OFF
and Testing It
Fig. 4: The micro-
phone arm of each
model switches the
microphone ON or
MUTEs it.
Refer to fig. 4.
15