Interline ECO FILTER SET Instructions De Service page 5

FILTER SYSTEM INSTALLATION
INSTRUCTIONS FOR FIBERCLEAN
» Once the filter system has been properly assembled, the
Fiber-clean chamber filled with Fiberclean and the hoses
connected as described above, you may begin with
filtration.
» Do not plug the system in until advised to do so below.
» Make certain the pump is not plugged in to a power
supply.
» Before operating the filter system, il is important to
ensure that the filter system is positioned outside the pool
and is lower than the pool's water level. The hose
connections must also be correctly connected and
fastened.
» lf you haven't done so already, fill your pool with water.
Ensure that the water level is at least 2,5 - 5 cm above the
top of the hose intake (Skimmer) and return ports in the
pool.
» The filter system is now vented. lf applicable, open the
vent screw on the upper side of the transparent filter
cover until the water flows out.
» Release the shut off valve at the intake port (Skimmer) in
the pool. lf you plugged the intake port (Skimmer),
remove the plug to allow the water to flow into the intake
hose.
» With the filter-pump system installed in a location level
lower than your pool's water level - water will
automatically flow into the pump-filter system.
» Allow the filter tank to fill with water.
» Check the filter system and the connection hoses for leaks
and resolve, if necessary. Leakage points may possibly
arise due to manufacturing tolerances, which need to be
resolved by wrapping teflon tape around the connections
before the connection hose is attached.
» Your filter system is now ready for use.
Cleaning filter balls
The filter balls in the filter tank ensure that dirt particles and
floating debris are effectively filtered over a long period of time.
The filter system will reduce its level of performance in
accordance with the amount of contamination in the water. This
must be checked at regular intervals.
lf you establish that performance levels are decreasing, please
follow one of these two options:
A: Replace the filter balls.
B: Wash the filter balls in a washing machine at a maximum
temperature of 30°C.
Filtering time
The water in the pool should be circulated and filtered at least 3
to 5 times in a 24 hour period, depending on the load and the
size of the filter system. The time required is based on the
performance of the filter system and the size of the swimming
pool. However, we r
8
EN
IMPORTANT NOTE
Care instructions
Visible contaminants are removed through the filtration system. This
is not true for algae, bacteria and other micro-organisms, which are
also a constant threat to clear, clean and healthy pool water. For Their
prevention or removal, special water treatment is available, properly
and permanently dosed, guarantee for swimmers any kind of
harassment and ensure proper hygienic bath water.
Cleaning
Use conventional cleaning products. Do not use solvent-based or
abrasive cleaning agents/tools, i.e. no hard sponges, brushes etc..
Storage
The product must be thoroughly dried after cleaning. After which, it
is to be stored in a dry location protected from frost.
Disposal
Disposing of packaging: The packaging material has been selected in
view of environmental concerns and disposability and is therefore
recyclable.The paper and cardboard can be recycled, as can the
plastic coverings. Disposing of the product: Applicable in the
European Union and other European states with systems in place for
col-lecting and sorting recyclable materials. Dispose of the product in
accordance with any laws and regulations applicable at your place of
residence.
Warranty conditions
Two years warranty after the date of invoice.
9