brennenstuhl MD Notice D'utilisation page 7

MD
When the low battery alert »
appears, the battery must be replaced with a new one. When dispo-
sing of used batteries, please observe your local legal stipulations.
Performing measurements:
SAMPLE USES
1. Remove the protective cover and place it on the
underside of the device.
2. Press and hold the on/off switch »
display appears in the display window.
Select wood »
pressing the selector button »
Insert the probe tip into the material to be tested (e.g.
wood) and read the value in the display window. At the
same time, an acoustic signal should sound. The higher
the tone, the higher the moisture content.
Press the »Hold«-button once »
display in the display window. This can be useful if you
wish to perform a reading in conditions of darkness or
poor visibility. The symbol »
display window and the reading will be displayed until
the »Hold«-button »
Press down the »Hold«-button »
3 seconds to turn the acoustic tone on or off.
Locating a leak in the wall
Place the probe on the surface to be
tested. Take a reading and read the
value from the display window. Repeat
this procedure in various places. If the
readings get higher, then you are get-
ting closer to the leak. If the values stop
increasing, you've found the leak.
Check the moisture content of construction
materials
e.g. concrete, tile, screed, plaster, carpets prior to
finishing.
Operating Instructions
« appears in the display window
« or construction materials »
« will appear in the
« is pressed again.
« until the
« by
«.
« to »freeze« the
« for longer than
7