Operating Instructions - brennenstuhl MD Notice D'utilisation

Operating Instructions

INTRODUCTION
This moisture meter is a useful instrument, for determining the
moisture content of wood or construction materials such as concrete,
tile, screed, plaster, carpets, etc. Prior to operational start of the
device, read the following instructions carefully and keep them for
future reference.
Protective cap
Measuring probe
Moisture level indicator:
Low
Middle
Hight
Wood display
Construction materials display
»Acoustic signal on/off« display
On-/off switch: Hold longer than three
seconds to turn on or off.
Low battery indicator
»Hold«-function display to »freeze«
measured values
µ Selector button: For switching from
»wood« to »construction materials«
and back
¸ »Hold«-button: To »freeze« the measu-
red values, press and hold for ca. 1 se-
cond, the next push turns the function
off again. To turn the acoustic signal on
and off, press and hold for longer than
three seconds.
¹ Battery cover (back)
Operation
Note: Be aware that the probe tip can cause injuries if used incor-
rectly. Put the protective cover back on when the device is not in use.
Keep the moisture meter away from children!
Inserting the Battery:
Remove the battery cover and insert a new battery (9V DC alkaline
block battery). Make sure you connect the poles correctly.
6
¶
¾
µ
¸
¹