Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NOTE: If the VTX-BELL module is used then this is also deactivated in
quiet mode, i.e. the connected receiver also does not emit a signal.
Brightness
Press the menu button (B.8) on the indoor station once and the OSD
will display 'Bright'. The brightness can now be increased using the
button (B.9) and reduced using the button (B.10).
Contrast
Press the menu button (B.8) twice on the indoor station and the OSD
will display 'Contrast'. The contrast can now be increased using the
button (B.9) and reduced using the button (B10).
Colour saturation
Press the menu button (B.8) three times on the indoor station and the
OSD will display 'Color'. The colour saturation can now be increased
using the button (B.9) and reduced using the button (B10).
INITIAL OPERATION
Connect the mains power supply unit to the 230 V network once all
the components are connected and encoded. Then ring the bell once in
order to initialise the system. This initialisation needs to be carried out
each time the system is disconnected from the mains.
OPERATION
1. Press the ringer button (A.4).
2. The set melody will sound at the corresponding indoor station(s).
3. Accept the conversation at the indoor station by briefly pressing on
the talk button (B.6).
4. If a door opener is connected you can activate the door opener by
pressing briefly on the door opener button (B.4).
5. Press the talk button again briefly in order to switch the system
back to standby.
TECHNICAL DATA
Outdoor station
Supply voltage:
15 volt DC / min. 1 A
Power consumption:
130 ± 50 mA
Temperature range:
-20 to +50°C
Dimensions:
161 x 235 x 40 mm (3 mm) + lens
Door opener connection:
12 volt DC / 1 A max.
Splash-proof in accordance with IP 44
Indoor station
Supply voltage:
15 Volt DC / min. 1 A
Power consumption:
130 ± 50 mA
Temperature range:
0 to +50°C
Dimensions:
220 x 164 x 22 mm
NOTES
The functionality of the unit can be affected by the influence of strong
static, electrical or high frequency fields (discharging, mobile phones,
radios, microwaves).
Cleaning and maintenance
Always disconnect mains powered units from the mains supply before
cleaning (disconnect the plug). The unit housing can be cleaned using
a soapy soft cloth. Do not use any abrasive materials or chemicals.
Remove dust build-up from ventilation slits using a brush and clean up
using a vacuum cleaner. Do not hold the vacuum cleaner nozzle directly
against the unit.
SAFETY INSTRUCTION
In the event of damage to the housing, connectors, power cables or
isolation shielding, switch off the device immediately and disconnect
from the mains power. ELECTRIC SHOCK – DANGER OF LOSS OF LIFE.
(Unplug the mains connector from the socket!). Damage should be
repaired immediately by a specialist!
Never carry out repairs yourself!
For reasons of safety and licensing (CE), unauthorised conversion and /
or modification of the product is prohibited.
Do not leave packaging material lying about since plastic foils and
pockets and polystyrene parts etc. could be lethal toys for children.
The interior unit is suitable only for dry interior rooms (not bathrooms
and other moist places). Do not allow the devices to get moist or wet.
15 15 15
ENGLISH | easy2wire VDB
GB
Publicité
Table des Matières
