Mounting Instructions - Klauke mini EK 15/50G Mode D'emploi

Instruction manual EK15/50, EK15/50G, EK35/4
__________________________________________________________________________________________________________________
The tools are a hand held tools and they are not supposed to be restrained in a vise. It is not
allowed to use the tools in a stationary application.
The tool is not designed for continued crimping operations. After a sequence of approximately
100 completed crimps you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of electric engines sparks can occur which might ignite highly
inflammable or explosive liquids and materials
Attention
Electric-hydraulic crimping tools should not be operated in pouring rain or under
water.

5.3. Mounting instructions

If other applications that exceeds those mentioned in table 2 must be performed with this tool it
is necessary to contact the manufacturer.
Instruction manual EK15/50, EK15/50G, EK35/4
__________________________________________________________________________________________________________________
The tools are a hand held tools and they are not supposed to be restrained in a vise. It is not
allowed to use the tools in a stationary application.
The tool is not designed for continued crimping operations. After a sequence of approximately
100 completed crimps you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of electric engines sparks can occur which might ignite highly
inflammable or explosive liquids and materials
Attention
Electric-hydraulic crimping tools should not be operated in pouring rain or under
water.
5.3. Mounting instructions
If other applications that exceeds those mentioned in table 2 must be performed with this tool it
is necessary to contact the manufacturer.
page 32
page 32