Cleaning And Care; Troubleshooting - DS Produkte 08365 Mode D'emploi

EN

Cleaning and care

PLEASE NOTE!
■ When cleaning, do not use any aggressive, scouring or toxic cleaners.
• Wipe the device off from the outside with a clean, damp cloth.
• To clean the water kettle (5) you can use a small amount of mild detergent if needed
and rinse the device off with clean, warm water afterwards.
• Keep the device in a ready-to-operate state. You should remove limescale from
water on a regular basis and according to the water quality in your region and the
frequency of use. Use a decalcifi er for this. Follow the instructions of the decalcifi er
when decalcifying the kettle.
• Store the device in a dry, clean, frost-free place that is protected from direct sunlight
and cannot be accessed by children or animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The device cannot
be switched on.
The device deac-
tivates before the
water boils.
16
Possible cause
The mains plug is not insert-
ed correctly in the socket.
No mains voltage is present
(due to defective plug socket
or triggered fuse).
The device is overheated.
No error can be identifi ed.
The water level is below the
MIN mark.
The On / Off switch (3) is
jammed.
Fix
Insert the mains plug cor-
rectly.
Try another
socket.
Check the fuse in the electri-
cal distributor (fuse box).
Wait until the device has
cooled off, fi ll it with water
and then retry.
Contact our customer service
department.
Make sure that the water
level is between the MIN and
MAX marks.
Remove the blockage.