Piusi MA Série Mode D'emploi page 51

3. Make sure that all of the pump's screws are well tightened.
4. Hoist the pump using suitable equipment according to the weight shown on the
plate.
5. If the pump has been forwarded with drain silencer disassembled, mount the
same.
WARNING
6. Position the pump correctly on the site chosen for installation, as close as possible
to the point of collection and secure onto the feet using the bolts supplied. Arrange
for enough room to carry out maintenance.
WARNING
1
3
Position and secure the pump horizontally using
hangers fixed to the ceiling or feet resting on the
ground. The product delivery manifold must al-
ways be positioned on the upper part according
to the signs:
"OUT" = DELIVERY (up)
"IN" = INTAKE (down) or according to the pump
model, check that the arrows shown onto the casing
are always pointing upwards.
diaphragm pumps with negative suction are affect-
ed by the following factors:
- viscosity and specific weight of the fluid;
- suction diameter and length.
Position the pump as close as possible to the point
of collection (within 2,5 m.) and in any case
more than 5 m.
2
4
never
51/208
5
EN