Identification Code - Piusi MA Série Mode D'emploi

D1 MARKINGS AND GENERAL INFORMATION
In compliance with the 94/9/CEE standards, the pumps carry the following identi-
fication marks:
II 3/3 GD c IIB T135°C
: safety symbol to Din 40012 attachment A.
II 3/3GD: surface equipment used in areas where the presence of gas, vapors or mists
in addition to clouds of combustible powder in the air is unlikely during normal op-
eration both in external and internal areas and, if it does occur, it will only persist for
a short period (ZONE 2).
c: protection by constructional safety (EN 13463-5).
IIB: Excluding the following products: hydrogen, acetylene, carbon disulphide.
T135°C: Class of admitted temperatures. The processed fluid temperature value
must fall within such class range and the user must comply with the instructions
contained in the manual and with the current laws. Furthermore, the user must take
into account the ignition point of the gases, vapors and mists in addition to clouds
of combustible powder in the air existing in the area of use.
E

IDENTIFICATION CODE

CODE PUMP
F00208P00 PIUSI MP 130
F00208A00 PIUSI MA 130
F00208P20 Piusi MP 140
F00208P10 Piusi MA 140
F00208P30 Piusi MP 180
F00208A10 Piusi MA 180
F00208P40 Piusi MP 190
F00208A20 PIUSI MA 190
Pump Diaphragm Diaphragm
casing air side
PP HYTREL
ALU NBR
PP HYTREL
PP NBR
PP HYTREL
ALU NBR
PP HYTREL
ALU NBR
43/208
Balls Balls seats
fluid side
PTFE PTFE
NBR NBR
PTFE PTFE
NBR NBR
PTFE PTFE
NBR NBR
PTFE PTFE
NBR NBR
O-RINGS
PP PTFE
ALU NBR
PP PTFE
PP NBR
PP PTFE
PPS-V NBR
PP PTFE
PPS-V NBR
EN