Outwell JIMBU STOVE Mode D'emploi page 2

INSTRUCTION MANUAL
• Jimbu stove
• Olida stove
• Appetizer 1 + 2
• Annatto
IMPORTANT read these instructions for use carefully so as to familiarize yourself with the appliance
before connecting it to its gas cartridges. Retain these instructions for future reference.
• This stove should only be used with Primus 220661, 220761, 220261 butane-propane mixture gas
cartridges with comply EN417. It may be hazardous to attempt to fit other types of gas cartridges.
• This stove is designed for use outdoors away from any flammable materials. The stove must be used
on a level, stable, non-flammable surface. The appliance should be protected from direct draughts but
in a well-ventilated place.
• No modifications should be made to any part of this stove and repairs and maintenance should only
be carried out by qualified persons.
Connecting to a Gas Cartridge
• If the stove is fitted to a cartridge that is empty then read "Removing Cartridge".
• This stove is fitted with sealing washer. Check that they are present and in good condition before
connecting to a cartridge. Do not use if a seal is damaged or worn.
• Do not use an appliance which is leaking, damaged, or which does not operate properly.
• Only change gas cartridges outdoors or in a well-ventilated place away from naked flames, any other
source of ignition, and other people.
• Close control valve by turning knob.
• In an upright position, carefully screw the gas cartridge onto the stove taking care not to cross thread.
Screw down until the sealing washer meets the cartridge. Tighten hand tight only.
• If there is a smell of gas or you suspect a leak take the appliance to a well-ventilated place outdoors
away from any sources of ignition. If you wish to check for leaks on your appliance, do so outside. Do
not try to detect leaks using a flame, use soapy water.
Instructions for use
• Holding a lit match near the burner whilst opening the control valve can light the stove. For versions
which have piezo ignition, hold and push the electronic igniter.
• When burner is lit, turn the control knob clockwise to decrease the heat intensity or extinguish, and
Anticlockwise to increase. Do not open valve beyond point where maximum intensity is reached as
this may cause unnecessary flaring and waste gas.
• Do not move the stove once lit as this may result in flaring. A warm up period of about 1 minute is
required.
• The stove must be used on a stable horizontal surface. Ensuring that the stove is secure.
• Always operate the stove at least 60cm away from walls and ceilings and never near flammable
materials.
2