SOLAC ID7840 Mode D'emploi page 13

TROUBLESHOOTING
Problem
It does not work
It only works for a few min-
utes even after charging
Water pressure is very low
The charging
indicator does not
illuminate when
charging.
Water does not come out
CLEANING
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
Causes
You've just purchased the prod-
uct or it has been left unused for
more than 3 months.
The filter is blocked
The battery has reached the end
of its lift cycle.
Charging time was insufficient
There is dirt stuck in the nozzle
The nozzle is deformed
The power plug has
not been connected
well.
Circuit malfunction
The tank is empty
The irrigator is tilted too much
while in use
Pump malfunction
FOR EU PRODUCT VERSIONS AND/OR IN
CASE THAT IT IS REQUESTED IN YOUR
COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
- The materials of which the packaging of this
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public recycling bins for each type of material.
- The product does not contain concentrations of
substances that could be considered harmful to
the environment.
Solution
Charge the unit for at least 16
hours
Clean the filter
Contact service center for sup-
port.
Charge the unit for at least 16
hours
Replace the nozzle
Please connect
the power source
well.
Contact service center for sup-
port.
Fill up tank
Use with the appliance in a
vertical state
Contact service center for sup-
port.