FRIEDHELM LOH Rittal CMC III DK 7030.690 Notice D'installation Et D'utilisation Succincte page 13

– Status: Current status of the Wireless Unit
Wireless Devices (locks)
The parameters of the connected radio comfort handles can be set via the base system web site
below the "Wireless Devices" entry (see section 1.1).
The following parameters can be set or viewed at the "Lock Control (Control)" level:
– Command: Select the mode for operation ("Normal Mode"), for registering a comfort handle ("Reg-
istration") or deregistering a comfort handle ("Deregistration").
– LifeCheck: The time interval in which a check is performed whether the handle is still available.
For each registered handle, advanced parameters can be set or viewed (see section 1.1) at each of
the "Lock 1" to "Lock 8" levels.
Note:
If the installation has been commissioned, the base system configuration should be
backed up as CFG file (configuration file) (see the Assembly, Installation and Operating
Instructions of the base system). This file allows the system configuration to be restored
quickly after any defects.
To determine whether any software updates are required: see www.rittal.com or contact
Rittal Service (see section 6).
6 Service
For technical questions, please contact:
Tel.: +49(0)2772 505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.de
Rittal CMC III Wireless Unit
Installation and operation, Service
EN
13