shark Rotator Lift-Away Pet ZU570 Série Guide D'utilisation page 6

CLEANING THE BRUSHROLL
Self-Cleaning Brushroll
The self-cleaning brushroll delivers nonstop hair removal. If you run over a hard or
sharp object or notice a noise change while vacuuming, check for blockages or objects
caught in the brushroll.
Using a coin, turn locks counterclockwise, then open the cover to access Brushroll.
NOTE: Cover hinges open but is not completely removable.
DEBRIS WRAPPED AROUND BRUSHROLL
Clean off any debris on the bristles.
NOTE: If any hair is wrapped around the brushroll, extending
cleaning time will allow the self-cleaning brushroll to remove
it for you. If some fibers remain wrapped around brushroll
after continued use, carefully cut debris with scissors and
remove from brushroll.
s h a r kc l e a n . c o m
DEBRIS BEHIND BRUSHROLL
If you run over a hard or sharp object or notice
a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
Clear away any dust, dirt, or blockages in
Debris Intake.
To close the cover, push down until it clicks
into place, then close the locks with a coin.
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod, and check hose
and opening on back of pod for blockages.
Detach wand from floor nozzle, tilt nozzle
neck back, and check opening for blockages.
Detach dust cup from vacuum pod. Empty dust
cup, remove debris from lint screen, and check
for blockages.
Detach wand from floor nozzle and handle,
and check both ends for blockages.
Detach handle from wand and hose from the
vacuum pod, and check openings for blockages.
s h a r kc l e a n . c o m