Maintenance - Fellowes 380-2 Mode D'emploi

To empty waste basket
If basket full light (J) is on, follow these steps until light turns off.
• Press manual forward button (F) to finish shredding any paper in the paper entry.
• Press the off [O] button.
• Open the cabinet door (A) and pull out the waste basket (D).
• Remove the full bag and replace with a new bag.
• Slide the waste basket (D) into the cabinet and shut the cabinet door (A).
To clear a paper jam
If paper jam light (I) is on, follow these steps until light turns off.
• Check the waste basket (D) and empty the bag if full.
• Press and hold the reverse [R] button to back paper out of the paper entry (B). Try pulling gently on the
paper to remove it from the shredder.
• Alternate between forward and reverse, as needed, until the jam clears:
– Press and hold the manual forward button (F) for a few seconds.
– Press and hold the reverse [R] button for a few seconds.
• Continue alternating between forward and reverse until the jam clears.
CAUTION: The shredder may be damaged if you alternate too rapidly between forward and
reverse.
• Unplug shredder, open cabinet door (A) and remove wastebasket (D).
• Carefully clear any paper shreds that have collected on under side of paper entry (B).
CAUTION: Model 380C-2 (confetti cut model) has exposed blades on underside of paper entry. Use
care when removing paper shreds.

Maintenance

Empty waste basket regularly to ensure the smooth functioning of the cutting cylinders. The shred-
der will not operate when the basket is full.
Oil confetti-cut model (380C-2) regularly to ensure proper operation.
If used at or near daily capacity, apply oil every time you empty the basket.
Use Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable-based oil in a long-
nozzle container (sample oil provided).
CAUTION: Do not use flammable synthetic oil, petroleum-based products, or aerosol
lubricants of any kind.
To oil the cutting cylinders
• Lift paper entry flap (N) and apply oil over full width of cutting cylinders through the paper
entry (B).
• Press and hold the manual forward button (F) for at least 3 seconds.
• Press and hold the reverse [R] button for at least 3 seconds.
• Repeat the forward/reverse sequence 3 or more times.
• Store oil bottle in slot (L) inside cabinet door (A).
5