General Maintenance; Lubrication; Environmental Protection - GreenWorks Tools 4101302 Manuel D'utilisation

GB
FR DE ES
The safety valve will automatically release air if the air
tank pressure exceeds the preset maximum. The valve
should be checked before each day of use by pulling the
ring by hand.
1. Turn the air compressor on and allow the tank to fill.
The compressor will shut off when the pressure
reaches the preset maximum.
2. Turn the air compressor off.
3. Pull the ring on the safety valve to release air for three
to five seconds to allow pressurized air to escape.
Release the ring. The safety release valve must
reset and hold pressure before all compressed air is
exhausted from the tank/pressure vessel.
4. Any continued loss of air after performing the above
steps indicates a problem with the safety valve.
Discontinue use and seek service before continued
use of the air compressor.
If air leaks after the ring has been released or if the
valve is stuck and cannot be actuated by the ring, do
not use the air compressor until the safety valve has been
replaced. Use of the air compressor in this condition could
result in serious personal injury.
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
Always wear eye protection during maintenance. If
operation is dusty, also wear a dust mask.
Always release all pressure, disconnect from power
supply, and allow unit to cool to the touch before
cleaning or making repairs on the air compressor.
IT NL PT DA SV
WARNING
WARNING
WARNING
WARNING
FI NO RU PL CS
English

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Any continued loss of air after performing the above steps
indicates a problem with the safety valve. Discontinue use
and seek service before continued use of the air
compressor. If air leaks after the ring has been released
or if the valve is stuck and cannot be actuated by the ring,
do not use the air compressor until the safety valve has
been replaced. Use of the air compressor in this condition
could result in serious personal injury.
Do not at any time let brake fluids, gasoline, petroleumbased
products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury. Electric tools used on fiberglass material,
wallboard, spackling compounds, or plaster are subject
to accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc.
Consequently, we do not recommend using this
product for extended work on these types of materials.
However, if you do work with any of these materials,
it is extremely important to clean the product using
compressed air.

LUBRICATION

All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further lubrication is required.

ENVIRONMENTAL PROTECTION

7
HU RO LV LT ET
WARNING
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
HR SL SK BG