Wall Mounting - Stiebel Eltron WPM-RBS Utilisation Et Installation

OPERATION | INSTALLATION
OPERATION
3. Operation
Note
The contractor will make all necessary adjustments.
Never make any modifications to the relay box.
4. Troubleshooting
Contact your local contractor.
INSTALLATION
5. Safety
Only qualified contractors should carry out installation, com-
missioning as well as maintenance and repair of the product.
5.1 General safety instructions
We guarantee trouble-free operation and operational reliabil-
ity only if the original accessories and spare parts intended for
the appliance are used.
5.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regula-
tions and instructions.
6. Product description
Appliance damage
!
Never connect external HE pumps directly to the heat
pump or the control unit on account of their high start-
ing currents. Connect them instead to the relay box,
otherwise the control unit could be damaged.
You can connect up to 6 HE circulation pumps to the relay box.
7. Standard delivery
The following are delivered with the appliance:
- 1 x connecting cable, 1,5 m long, for control voltage
- 1 x power cable, 1,5 m long, for supply voltage
- 3 x screws Ø 3.5 x 40
- 3 x all purpose rawl plugs Ø 6 mm
- 2 x locking slide for mounting inside a control panel
- 12 x cable grommets with strain relief
WPM-RBS
8. Installation
Fit the relay box directly to a wall or into a control panel. Protect
the relay box against humidity, dirt and damage. Observe the
permissible ambient temperature.
f Open the relay box.
8.1

Wall mounting

f Mark out the location for the holes to be drilled.
f Drill the holes and then insert rawl plugs.
f Turn the top screw far enough into the rawl plug that you
can hook the casing over.
f Secure the casing with two more screws in the lower sec-
tion of the casing.
| 9