Publicité
7
EN
The example of the conformity declaration is found in the penultimate page of the manual.
7. DISPOSAL
Waste electrical products should not be disposed of together with household waste. Please recycle where
facilities exist. Check with your local authority or retailer for recycling advice.
Do not dispose of electrical equipment with household waste material. In observance of European Directive
2012/19/EC on waste electrical and electronic equipment and its implementation in accordance with national
regulations, electric equipment that has reached the end of its life must be collected separately and recycled
in an ecologically compatible way. If electrical equipment is disposed of in dumps or in landfills, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health and well-being. For further information
on the disposal of this product, contact a domestic waste collection authority or your dealer
8. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
1. Bag full
2. Blocked tube
3. Blocked impeller
Unit will not blow or
4. Dirty bag
mulcher.
Air Velocity
5. Torn bag
Weight (Battery
6. Bag unzipped
Pack not included)
7. Battery is not secure.
8. Battery is not charged.
1. Battery is not secure.
2. Battery is not charged.
3. Power/speed switch is in
Unit will not start.
the OFF position.
4. Vac tubes are not correctly
installed.
5. Intake gate/cover is not
closed.
DISPOSAL / TROUBLESHOOTING
SOLUTION
1. Empty the bag.
2. Clear the blockage.
3. Clear the blockage
4. Clean the bag.
5. Replace the bag.
6. Zip up the bag.
7. To secure the battery pack, make sure the latches on the
top of the battery pack snap into place.
8. Charge the battery pack according to the instructions
included with your model.
1. To secure the battery pack, make sure the latches on the
top of the battery pack snap into place.
2. Charge the battery pack according to the instructions
included with your model.
3. Press the on/off switch.
4. Check vac tubes to ensure that they are allowing the switch
to be engaged when correctly installed.
5. Ensure that gate/cover is fully closed and locked.
Publicité
Chapitres
Dépannage
