Special Safety Instructions; Before Start-Up - Matrix AK 18-SP Traduction De La Notice Originale

.
Always switch on the machine before making
contact with the material.
.
Remove wrenches and setting tools before you
switch on the machine.
.
Do not overload the machine. If the speed falls,
reduce the load on the machine or switch it off.
Using suitable electric tools you can work more
safely and better within the specified capacity
range.
.
Secure the workpieces to prevent them turning
with the machine, for example using a clamp or
a vice. Do not machine any workpieces that are
too small to secure. If you hold the workpiece
with your hand, you will not be able to operate
the tool safely.
.
Keep electric tools out of the reach of children.
CAREFUL HANDLING AND USE OF ELECTRIC
TOOLS
.
Keep the tools clean and functional to enable
you to work better and more safely with them.
.
Use only accessories that have been
recommended by the manufacturer.
.
Never cut, drill or saw into concealed areas
which may contain electric cables, gas or water
pipes. Use suitable detection equipment to locate
these cables and pipes.
.
Do not machine materials that contain asbestos.
.
Do not cut workpieces which are thicker than
the maximum cutting depth of the cutting disc.
.
Conduct an operating test of at least 30 seconds
without loading the machine.
.
Always switch off the machine and allow it to
reach a standstill before you put it down.

6. Special safety instructions

.
Only use accessories recommended by the
manufacturer.
.
Make sure that you are using the correct
rechargeable battery block.
.
Keep the outside surface of the rechargeable
battery block clean and dry.
.
Only charge the rechargeable battery with the
charger provided by or recommended by the
manufacturer.
.
Only dispose of used rechargeable batteries at
the receiving stations that are provided for this
purpose.
.
Never cut, drill, or saw in concealed areas where
there may be electric, gas, or water lines. Use a
suitable detector to nd such lines..

7. Before Start-up

.
Keep rechargeable battery away from heat and
re.
.
Don't store the device close to heat sources or in
direct sunlight. Protect it against temperatures
o
above 50 C. Let hot rechargeable battery cool
before recharging.
.
The exchangeable rechargeable battery is not
charged when delivered. Therefore, charge the
rechargeable battery before using it for the rst
time.
.
Observe the mains voltage given on the type
plate.
.
A rechargeable battery reaches its full capacity
after approximately five charge/discharge cycles.
23