.
Nc rechargeable batteries discharge even if they
aren't being used. Therefore, charge the
rechargeable battery regularly.
.
Never completely discharge the rechargeable
battery.
.
You will have long service life if the rechargeable
battery is regularly loaded and then recharged.
8. Working with the cordless drill
.
Charge the battery before you use the cordless
drill for the first time.
Charging and inserting the battery
.
Slide the direction switch (2) to the centre
setting before you take the battery out of the
machine. This will ensure that the drill will not
start accidentally.
.
Press the side snap fastening (7) and remove the
battery (6). (B2)
.
Place the power supply plug in a 220-240 V~50/
60 Hz socket.
.
Connect the power supply to the charger (8).
.
Place the battery into the charger station. The
incorrect position has a block – do not use force.
.
Please see below charging control for lamp
which is assembled on charging base. (3~5h
slow charger)
1. After connecting with power supply, the green
lamp is bright.
2. After inserted the battery pack, the red and
green lamp will be bright.
.
The duration of the charging process for fully
discharged batteries is approximately 5 hours, it
24
will be less for topping o the battery's charge.
.
The charger will not cut out when the battery
is fully charged. Monitor the charging process.
Take the battery out of the charger after a
maximum of 5 hours.
.
Push the battery into the machine with clean
contacts until it engages.
Recharging
.
Regular recharging after lengthy use and after
lengthy periods of inaction will extend the service
life of the battery.
Setting the torque
Your cordless drill is fitted with a 16-level torque
setting (4) with a slip coupling. This enables you
to select the perfect setting for the job in hand.
.
Start work with a low torque setting.
.
When you insert the first screw you will find out
how much torque is required.
.
If the torque provided by the current setting is
inadequate, set it to the next level.
.
If the screw can be inserted as intended down to
the surface of the workpiece, the drill/screwdriver
is set to the correct torque.
Keyless chuck
.
To insert drill bits: Set the drill to turn clockwise,
insert the bit and hold the front ring on the
chuck. Start the drill at a slow speed.
.
To remove drill bits: Set the drill to turn anti-
clockwise and hold front ring on the chuck. Start
the drill at a slow speed.