Makita DGA419 Manuel D'instruction page 11

Adjusting angle of wheel guard
WARNING:
Make sure that the wheel guard is
securely locked by the lock lever with one of the holes
on the wheel guard.
The angle of the wheel guard can be adjusted by rotating
the wheel guard with pushing it down while pushing the
lock lever. Adjust the angle of the wheel guard according
to the work so that the operator can be protected.
► 1. Wheel guard 2. Hole
Installing or removing X-LOCK
wheel
CAUTION:
Use only original X-LOCK wheels
with the X-LOCK logo. This tool is dedicated to
X-LOCK.
The maximum clamping gauge of 1.6 mm (1/16") can
only be guaranteed with original X-LOCK wheels.
Use of any other wheels may lead to insecure clamp-
ing, and cause the clamp tool to come loose.
CAUTION:
Do not touch the X-LOCK wheel
immediately after operation. It may be extremely
hot and could burn your skin.
CAUTION:
Make sure that the X-LOCK wheel
and holder of the tool are not deformed and are
free from dust or foreign matters.
CAUTION:
Do not put your finger near the
holder while installing or removing the X-LOCK
wheel. It may pinch your finger.
CAUTION:
Do not put your finger near the
release lever while installing the X-LOCK wheel. It
may pinch your finger.
NOTE: No additional parts such as inner flanges
or lock nuts are required to install or remove the
X-LOCK wheels.
1. To install the X-LOCK wheel, make sure that both
catches are in the unlocked position.
If not, push the release lever from A side to lift B
side, then pull the release lever from B side as illus-
trated. The catches are set in the unlocked position.
1
1
2
A
► 1. Catch 2. Release lever
2. Place a central position of the X-LOCK wheel on the holder.
Make sure the X-LOCK wheel is parallel to the
flange surface and with the correct side facing up.
3. Push the X-LOCK wheel into the holder. The
catches snap into the lock position with a click and
fix the X-LOCK wheel.
3
4
► 1. X-LOCK wheel 2. Holder 3. flange surface 4. Catch
11 ENGLISH
2
1
2
B