Safety Regulations; Proper Use; Technical Data - Bavaria BPO 1100 E Mode D'emploi D'origine

Anleitung_BPO_1100_E_SPK1__ 03.01.14 12:18 Seite 10
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1. Spindle lock
2. Front grip
3. ON/OFF switch
4. Speed control
5. Rear grip
6. Power cord
7. Polishing / sanding disk

3. Proper use

The machine is designed for polishing coated
surfaces and for sanding wood, iron, plastic and
similar materials using the appropriate abrasive
paper.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
10
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
Contact with the unguarded wheel (injuries
n
through cutting)
Reaching into the wheel while it is still rotating
n
(injuries through cutting)
Catapulting of parts of the wheel (injuries through
n
cutting or bruising)
Catapulting of parts of the material being
n
processed (injuries through cutting or bruising)
Risk of fire from flying sparks
n
Damage to hearing if the compulsory hearing
n
protection is not used (hearing loss)
Inhalation of abrasive particles from the material
n
and wheel
Electric shock upon contact with non-insulated
n
electrical parts
If the instructions listed in the operating instructions
are not adhered to, improper handling of the
equipment may result in other residual risks

4. Technical data

Voltage:
Power rating:
Speed n:
Polishing / sanding disk diameter:
Connection thread:
Totally insulated
Weight:
230V ~ 50 Hz
1100 W
1000-3300 min -1
180 mm
M14
II/
2.2 kg