Lindy USB 3.0 Docking & Clone Station Premium Manuel Utilisateur page 2

Software CLONE Function
Make sure that no data is stored on the target hard drive – otherwise you
will completely overwrite it during the clone process!
Install the software CloneDrive from the included CD. When the
installation is complete, you will find the corresponding icon in the
taskbar.
For first time installation, you will have to enter the serial number, which
you can find on a sticker at the bottom of the USB 3.0 HDD Docking &
Clone Station.
You can choose now to either clone the external disk, which means that
the hard disk in the Source Port will be cloned to the hard drive in the
Target Port.
English
Install the source and target HDDs into the appropriately labelled bay
(Source and Target), connect the USB 3.0 HDD Docking & Clone Station
to your computer via USB 3.0 cable and press the power switch on.
You will then see information on the hard drives of both bays:
Or you can choose the internal hard disk of the computer as a source.
Both hard disks in the USB 3.0 HDD Docking & Clone Station can then
be your target hard disks.
Click either "Start" on the right bottom side for beginning the clone
process or push the Clone button on the USB 3.0 HDD Docking & Clone
Station twice.
You can clone from a smaller to a bigger hard drive as well as from a
bigger to a smaller one. If the target hard drive is smaller than the source,
the software will resize the partition. However, a completely full, bigger
hard drive cannot be copied to a smaller one.