GO2 Rangierhilfe RH 1 Mode D'emploi Et Instructions De Montage page 20

Figure 20
Mark connection pipe in the centre. Loosely attach the drive
assemblies to the connection pipe.
Do not screw in the supplied threaded bolts (g) yet.
Figure 21
Place the mounting set (b) on the vehicle frame and bolt it on
with the two bolts (c) in such a way that it is just possible to
move it along the frame.
c
Washer 8
(8 x)
Self-locking nut M8 (4 x)
Figure 22
Bolt the drive assemblies with the cross-strut on the mounting
set with the U-bracket (d) in such a way that it is still just poss-
ible to move it.
d
Washer 10
(16 x)
Self-locking
nut M10 (8 x)
Figure 23
20
f
g
M8 x 60 (4 x)
b
M10 x 50 (8 x)
RH 1 Manoeuvring Assistant
Position the drive rollers in such a way that they are roughly at
wheel hub height (middle of wheel ± 30 mm).
Figure 24
For height differences of up to 45 mm, GO
spacer plate kit (2 x 15 mm) as an accessory to compensate
for these. Up to three spacer plates can be used on each side.
The set of bolts is required to attach the spacer plates.
For height differences of more than 45 mm the low chassis
installation kit must be used. Make sure that there is adequate
ground clearance (at least 110 mm).
Set the correct distance between tyres and rollers (20 mm) by
moving the drive assemblies (in the disengaged position) in the
longitudinal direction. The movable connection pipe enables
the frame width to be adjusted.
20 mm
Figure 25
Move the drive assemblies in a lateral direction in such a
way that as much of the tread area of the tyre as possible is
covered.
Ensure that there is an adequate distance between the gear-
box and the tyres / shock absorbers so that they do not come
into contact.
Figure 26
The minimum distance with the drive rollers engaged is
10 mm.
Once the drive assemblies have been correctly positioned,
tighten the nuts and bolts of the mounting set a little, then
check the required distances again. The weight of the caravan
must be resting on the wheels when doing this.
Place the movable connection pipe in the centre (use the
marking) and fix each side with 2 threaded bolts (g) M8 x 12
(15 Nm).
The threaded bolts are coated with sealant, and must
therefore only be bolted in once.
± 30 mm
min. 110 mm
can provide a
2
min. 110 mm
min.
10 mm