Sangean RCR-2 Mode D'emploi page 13

Alarm with radio
1. Select the desired station by station memory button 1-7 or simply
tune the radio station.
2. Set the desired radio alarm volume.
3. Select alarm system 1 or 2 by pressing the alarm 1 or 2 button.
Display will blink selected alarm system symbol.
4. Press alarm SET button 13, display will blink both alarm hour and
alarm mode with a beep.
5. Press alarm Mode button 17 to select alarm radio mode until
display shows
6. Press + or – to adjust required alarm hour then press SET button
again, display minute digits will blink. Press + or – button to adjust
required alarm minute.
7. Press week day selection 1-7 ( Sunday – Saturday ) to select
required alarm week day. Display will show the days of the week
on which you wish to be woken by the alarm.
8. Press alarm button 1 or 2 to confirm all the alarm set with a beep.
Display will show
Note:
If the alarmed week day(s) or alarm mode is not selected,
display will blink all the week days or show
seconds indicating the alarm is not set and disappear,
the alarm will not be activated.
Note:
If you like to be awoken by the radio station you are listening,
press Alarm system 1 or 2 for more than 2 seconds, the
appliance will store the radio alarm station, then follow above
procedures 2-8 to set radio alarm.
.
indicating radio alarm is set.
GB
for a few
12