Installation And Connection; Operation - Bartscher 200063 Mode D'emploi

5.2 Installation and connection

•
Unpack the device and remove all packing material.
•
Put the device in a safe place that can support its weight and is not heat sensitive.
•
Never place the device at the edge of a table to avoid accidents.
•
Never put the device in a moist or wet area.
•
Do not place the device near an open flame, electric heater or other heat source.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.

5.3 Operation

•
Before using the device, clean it in accordance with the instructions contained in
6.2 „Cleaning and descaling".
•
Pour the desired amount of water into the tank (up to the „MAX" indicator).
•
Before turning the device on, ensure it contains a fluid suitable for human
consumption. The device must not hold liquids such as acids, oils, etc.!
WARNING! Danger of burns!
Do not exceed the device's maximum capacity. Overfilling the tank may result in
splashing and burns!
CAUTION!
To reduce heating time and save energy, warm water can be used!
•
Place the lid on the tank and close it by turning clockwise.
- 24 -