Fuse Replacement - HQ Power VPA2100MN Notice D'emploi

4. Fuse Replacement

• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (250Vac / 3.15A fuse, 5 x 20mm, order code
FF3N):
1. Unscrew the fuse holder cap at the back with an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the old fuse holder and fasten it with the screwdriver.
5. Use
a. Front Panel
1. INPUT GAIN CONTROLS for channel A and B
2. LED POWER ON/OFF indication
3. SIGNAL LED DISPLAY INDICATOR: this green LED indicates a safe operation. The output level will be between
-30dB and 0dB.
4. CLIPPING LED DISPLAY INDICATOR: this red LED indicates a state of over-modulation (distortion at extremely
high volumes). In this case check the output signal of your mixing panel and turn down the GAIN CONTROL.
Keep in mind that the amplifier cannot correct any distorted signal.
5. POWER ON/OFF switch: the main switch will light when on.
b. Back Panel
6. OUTPUTS channel A and B
7. FUSE HOLDER
8. MAINS connection
9. INPUT CHANNEL A and CHANNEL B: inputs through 6.35mm balanced mono jacks
10. INPUT CHANNEL A and CHANNEL B: inputs through balanced XLR
VPA2100MN_v2 4 VELLEMAN