General Characteristics - Cembre PNB-1 Notice D'utilisation Et Entretien

Pneumo-hydraulic bench press with automatic work cycle controlled by pneumatic logic, suitable
for installing all types of electric connectors up to 50 mm

1. GENERAL CHARACTERISTICS

– Inlet air pressure: ................................................................................................................................. 6 bar
– Compression force: ............................................................................................................................. 3600 daN
– Die stroke:............................................................................................................................................... 16 mm
– Dimensions: length ............................................................................................................................. 320 mm
width .............................................................................................................................. 180 mm
height ............................................................................................................................. 700 mm
– Weight: ..................................................................................................................................................... 24 kg
– Air connection: ..................................................................................................................................... 1/4" Female
– Recommended oil: .......................................................ENI ARNICA ISO 32
– Acoustic noise (Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
– The weighted continuous acoustic pressure level equivalent
A at the work place L
– The maximum value of the weighted acoustic displacement
pressure C at the work place L
– The acoustic power level emitted by the machine
L is equal to ........................................................................................................................................... 72,2 dB (A)
WA
– The work area is provided with a safety guard in compliance with the safety standards as regards
size and which has slots in the side for the passage of the conductors with connector to be com-
pressed. Changes to or tampering with the above protection releases the supplier from all civil
and penal responsibility. Therefore, should parts of the guard get broken and before using the
press again, the guard must be replaced completely so as to restore the safety conditions. The
protection is the "fi xed with start control" type and is fi xed to the frame of the press by a locking
knob; removal of the guard impedes the press from being used in that both the pneumatic logic
and the main feed valve are disabled; all the air present in the pneumatic circuit downstream of
the main valve is automatically released.
– The press is in compliance with the Directive:
2006/42/EC; it is marked
a certifi cate of compliance.
– The press is supplied complete with:
- transportation cap (13) for the oil tank (to be used only for transport).
- oil fi ller cap with dipstick (14).
- manual control (26).
- Qty 4 safety guards (17-18-19-20).
- 5 mm "T" allen key.
- 3 mm allen key.
- die holder case type "VAL 75".
3
PNEUMO-HYDRAULIC BENCH PRESS
TYPE PNB-1
is equal to .................................................................................................... 65,8 dB (A)
pA
is ............................................................................................< 130 dB (C)
pCPeak
, and is supplied with an instruction and maintenance manual and
2
.
SHELL TELLUS OIL TX 32
ENGLISH
or
or equivalent